Saturday, October 12, 2019
Saturday, June 8, 2019
Wednesday, December 12, 2018
Tuesday, October 23, 2018
Scintillation Mode for Multi-Channel Analyzer kit
SCINTILLATION mode for searching with NaI(Tl) / CsI probe.
In firmware 1.03a we have added scintillation mode for the MCA module. The mode allows you
to use your NaI(Tl) probe for searching of low contaminated areas. First time you activate the
scintillation mode the software will run 5 minutes calibration to calculate average and standard
deviation for your probe.
Menu Functions related to Scintillation mode:
SCINT MODE – activate scintillation mode, restart applied by auto.
BEEP FREQ.HZ – set for sounder clicker frequency.
DEALAY N-pulses – the module will click on every N particle detected.
CONFIDENCE SIGMA – set 2 for fast searching or 3 for more accurate search but slower
response of alert.
CALIBRATE SD – will trigger 5 minute scintillation re-calibration on the next restart.
AVERAGING SEC – 2 or 3 seconds to average CPS results. Use 2 for faster search.
Take note, some MCA menu settings for acquisition spectrum is not active in scintillation mode!
Switch back to spectrum mode by setting SCINT MODE to OFF.
Monday, September 3, 2018
Thursday, August 23, 2018
PCB of gamma spectroscopy driver with USB
The board has adjustable high voltage converter with positive polarity output for 2-wire configuration of a photomultiplier probe. It has pulse amplifier with potentiometers to adjust pulse rise/decay time and amplification factor. Signal is coupled to USB audio chip that detected by standard Windows drivers as an general audio-device.
This gamma spectroscopy driver is directly compatible with popular software like Theremino, PRA and BecqMoni2011.
This gamma spectroscopy driver is directly compatible with popular software like Theremino, PRA and BecqMoni2011.
Subscribe to:
Posts (Atom)